Industrial Coatings

ST 2000
Acrylic Concrete Sealer

Product Specification Sheet

 Product Specification Sheet

Description: A single component, top quality acrylic polymer for use over properly prepared concrete. This product dries to a clear, colorless, abrasion and chemical resistant film that provides a waterproof sealer that also resists most acids, household chemicals, oil and grease.

Usage: Provides a clear coating over concrete that is easy to keep clean and is very easy to apply. (Almost error proof.)

Preparation Surface to be coated must be cured, firm, dry and clean; free of dust, oil, grease, and wax. Loose paint, chalk, rust or scale must be removed. Any contamination will adversely affect the performance of the coating.

Application: Product can be applied by brush, roller, or sprayed. Coverage 250 to 300 square feet per gallon , depending on porosity, texture and method of application. Apply coating only when air and surface temperature is above 50’ F.

Characteristics:
Pot life – 8 hours at 70 degrees F.

Shelf life – I year.

Clean up – Xylene or lacquer thinner

Dry time – to touch 5 to 10 minutes at 70 degrees F and 50% per cent relative humidity. Thorough dry 25 minutes.

Open to traffic 6 to 8 hours.

Caution: Keep away from children. Do not take internally. If taken, contact physician. When spraying a protective mask should be worn to avoid inhaling. In the event of eye contact, flush eyes with water for 15 minutes and seek medical attention. Non-flammable.

KEEP FROM FREEZING.

 
[HOME]  [EMAIL] [CONTACT] [ABOUT US] [COMMENTS
[REFERENCES] [BEFORE & AFTER] [MORE PICTURES] [PRODUCT LIST]
[PRICE LIST] [DISTRIBUTOR APPLICATION] [ADVANCE FLOOR TROUBLESHOOTING] [PRI]

This site was last updated Tuesday November 18, 2003 06:03 PM -0800
©IMAGE2000 1998, 1999, 2000, 2001, 2002, 2003, 2004