Image 2000
Superior Industrial Coatings

Product Specification Sheet

Elastomeric Waterproofing Coating #3100-12

Advantages: A true weatherproofing for concrete, concrete block and brick. A high build system that will seal pinholes, irregularities and minor cracks. Expands and contracts during changes in temperature so that it will not crack. Will totally eliminate water absorption or penetration.

Disadvantage: Cost many times that of ordinary paint. Goes on very thick so not as many feet coverage per gallon as paint.

Usage: Adds both beauty and protection. Outstanding ultraviolet resistance for excellent durability. It is high build which will fill and bridge minor cracks and surface imperfections and protects against water penetration. It has breath ability which allows moisture vapor to escape from substrate. Good chemical resistance and superb resistance to dirt pick up. Low odor during application.

Preparation: Surface to be coated must be cured, firm, dry and clean; free of dust, oil, grease, and wax. Loose paint, chalk, rust or mil scale must be removed. Mildew or other contamination will adversely affect the performance of the coating.

Application: Stir thoroughly prior to use. Apply only when air and surface temperatures are above 50 degrees F. Avoid painting late in day when dew or condensation is likely to form or if rain is imminent. Protect from freezing.

Pot life – 15 to 20 minutes at 70 degrees F.
Shelf life – I year.
Clean up – Image Sol Thinner #125 or RT 130.
Weight per gallon: 10.85 lbs.
Percent solids by weight 56.5, by volume 50.2.
Elongation at break: 670. Tensile strength 550.
Flash point exceeds 200 degrees F.

Caution: Keep away from children. Do not take internally. If taken, contact physician. When spraying a protective mask should be worn to avoid inhaling. In the event of eye contact, flush eyes with water for 15 minutes and seek medical attention. 



This site was last updated Wednesday May 15, 2002 05:26 PM -0700
ŠIMAGE2000 1998, 1999, 2000, 2001, 2002, 2003, 2004